Table of Contents
Advertisement
136 Commissioning
</dg_
8.6.35
"Configuration of SNMP v3 Users" Page
The general settings for SNMP v3 are shown on the "Configuration of SNMP v3
Users" page.
8.6.35.1
"Actually Configured v3 Users" Group(s)
Table 104: WBM "Configuration of SNMP v3" Page – "Actually Configured v3 Users" Group
Parameters
Count
8.6.35.2
"v3 User n" Group(s)
A group with the following information is displayed for each user:
Table 105: WBM "Configuration of SNMP v3 Users" Page – "v3 User n" Group(s)
Parameters
Security Authentication
Name
Authentication Type
Authentication Key
Privacy
Privacy Key
Notification Receiver IP
Click [Delete] to delete the user. The changes only take effect after restarting the
controller. For this purpose, use the WBM reboot function. Do not shut down the
controller too early!
Manual
Version 1.1.0
Explanation
The number of configured v3 users is displayed.
Explanation
The user name is displayed.
The authentication type for the SNMP v3 packets is
displayed here.
Possible values:
- Use no authentication ("None")
- Message Digest 5 ("MD5")
- Secure Hash Algorithm ("SHA")
The authentication key is displayed.
The encryption algorithm for the SNMP message is
displayed here.
Possible values:
- No encryption ("None")
- Data Encryption Standard ("DES")
- Advanced Encryption Standard ("AES")
The key for encryption of the SNMP message is
displayed here. If nothing is displayed here, the
"authentication key" is automatically used.
The IP address of a trap receiver for v3 traps is
displayed here. If no v3 traps are to be sent for this
user, this field remains blank.
Touch Panel Marine Line
762-6xxx/8000-000x TP 600
Advertisement
Table of Contents
