GMC Sierra Owner's Manual page 52

hold 1, 2, or until the saved position is
reached. Follow the instructions under
Saving Memory Positions.
The vehicle identifies the current driver s RKE
transmitter number (1 8). See Remote
Keyless Entry (RKE) System Operation (Key
Access) 0 11 or
Remote Keyless Entry (RKE) System
Operation (Keyless Access) 0 13. Only RKE
transmitters 1 and 2 can be used for
automatic memory recalls. A Driver
Information Center (DIC) welcome message
indicating the transmitter number may
display for the first few ignition cycles
following a transmitter change. For Seat
Entry Memory to work properly, save the
positions to the memory button (1 or 2)
matching the RKE transmitter number
displayed in the DIC welcome message.
Carry the linked RKE transmitter when
entering the vehicle.
Vehicle Personalization Settings
To have the Seat Entry Memory
movement begin when the vehicle is
started, select the Settings menu, then
Vehicle, then Seating Position, and then
Seat Entry Memory. Select On or Off. See
Seat Entry Memory later in this section.
To begin Seat Exit Memory movement
when the vehicle is turned off and the
driver door is opened, or when the vehicle
is turned off with the driver door already
opened, select the Settings menu, then
Vehicle, then Seating Position, and then
Seat Exit Memory. Select On or Off. See
Seat Exit Memory later in this section.
See Vehicle Personalization 0 132 for
additional setting information.
Identifying Driver Number
To identify the driver number:
1. Move your RKE transmitter away from
the vehicle.
2. Start the vehicle with another key or RKE
transmitter. The DIC should display the
driver number for the other RKE
transmitter. Turn the vehicle off and
remove the key or RKE transmitter from
the vehicle.
3. Start the vehicle with the initial key or
RKE transmitter. The DIC should display
the driver number of your RKE
transmitter.
Saving Memory Positions
Read these instructions completely before
saving memory positions.
Seats and Restraints
To save preferred driving positions 1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY.
A DIC welcome message may indicate
driver number 1 or 2.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a beep will sound.
4. Immediately press and hold the 1 or
2 memory button matching the above
DIC welcome message until two beeps
sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be saved and
two beeps will not sound. Repeat
Steps 3 and 4.
1 or 2 corresponds to the driver number.
See Identifying Driver Number
previously in this section.
5. Repeat Steps 1 4 for a second driver
using 1 or 2. RKE transmitters 3 8 will
not save memory positions.
To save the position for and Seat Exit
Memory features, repeat Steps 1 4 using
. This saves the position for getting out
of the vehicle.
51