Cleaning And Maintenance; Troubleshooting - HoMedics TOTALCLEAN AP-DT10-SA Instruction Manual

CLEANING & MAINTENANCE
CLEANING THE HEPA-TYPE
FILTER
NOTE: For best performance,
vacuum the HEPA-type filter once
a month under normal usage.
1. Unplug the air purifier.
2. Remove the HEPA-type filter
as described in the Replacing the HEPA Type Filter section.
3. Vacuum the white side of the HEPA-type filter using the brush
attachment of your vacuum cleaner, cleaning it thoroughly.
4. Place the HEPA-type filter back into the air purifier and close
grille.
5. Plug the power cord into a standard AC outlet.
TO CLEAN THE OIL TRAY
Open the oil tray and remove the
pad. Essential oil pads should be
changed when switching to a
different essential oil scent. If
continuing to use the same scent,
set the essential oil pad aside for
reuse. Wipe down the inside of the
oil tray with a soft cloth. Place the essential oil pad back in the tray
and close.
NOTE: Leave the essential oil pad out of the oil tray when storing.

TROUBLESHOOTING

PROBLEM
Unit will not operate
Reduced airflow
Reduced odour removal
Excessive noise
Replace filter light remains lit
after filter replacement
FOR BEST PERFORMANCE
• NEVER use water or any household cleaners or detergents to
• Clean off the outside of the unit with a dry cloth as needed.
• NEVER use water, wax, polish, or any chemical solution to clean
• Clean off the grille cover using a damp cloth or the brush
• Vacuum the pre-filter monthly under normal usage conditions.
• Replace the HEPA-type filter every 12 months under normal
• Always use a genuine HoMedics replacement filter for optimal
To purchase genuine HoMedics replacement/spare parts please
visit www.homedics.co.uk
3 Pack of aroma pads - ARM-PAD3
Aroma tray - AP-DT10ARMTR
HEPA filter - AP-DT10FL
POSSIBLE CAUSE
• Unit is not plugged in
• Power button not pressed
• No power to unit
• The back grille may be blocked
• Pre-filter needs vacuuming
• The filter needs to be replaced
• The filter needs to be replaced
• The unit is not level
• The replace filter indicator needs to be
reset
GB
4 I
clean the HEPA-type filter.
the outside of the unit.
attachment of your vacuum as needed.
usage conditions.
performance.
• Plug unit in
• Press the power button to turn the power on
• Check fuses, try a different outlet
• Check to make sure nothing is blocking the
back grille and air outlet
• Vacuum the pre-filter with the brush
attachment of your vacuum cleaner
• Replace the filter
• Replace the filter
• Place the unit on a flat, level surface
• Press and hold the ioniser button for 3 seconds
until the replace filter light turns off
SOLUTION