Technical Specifications; First Use And Charging The Batteries - therm-ic I-Pack Mono button B Instructions For Use Manual

INSTRUCTIONS FOR USE / ENGLISH
USB charger
• Charge indicator light x 2 (2.1)
• Charger cord with plug (2.2)
• USB connector (2.3)
• Optional wall plug universal charger 5V/2A
(with adaptors for use in different countries)

TECHNICAL SPECIFICATIONS

USB charger (spare part available from Therm-ic)
USB charger* Input 5V / 2A
Optional wall
plug universal
Input 110V -240V ~
charger* 5V / 2A
(50 - 60 Hz)
2A (with adaptors
max. 300 mA.
for use in different
countries)
"Dual" Lithium
3,7V / 2600 mAh
batteries*
* spare parts available from Therm-ic

FIRST USE AND CHARGING THE BATTERIES

The batteries must be charged before first use.
Please ensure that the Therm-ic Boot Integration
System are switched OFF while charging.
1. Plug in the USB cable. The charge indicator
Output 4,2V /
2. When the batteries are fully charged,
1A x 2
Output 5V /
2000 mA.
3. Unplug the two Boot Integration System
Charging time is approximately 4-6 hours.
Note that at half time of the charging time
light (2.1) will light up green. Next, plug the
two boot connectors (1.3) into the charger
(2.2). Charging will start automatically and
the charge indicator light (2.1) turns red and
remains on during charging.
charging will stop automatically and the
LEDs in the charge indicator light (2.1) will
turn green again.
connectors from the USB charger.
9