Display Assembly - HP ProBook 635 Aero G7 Maintenance And Service Manual

6. Lift the side of the system board upward (2), and then pull the system board away from the connectors
on the side of the computer to remove it (3).
NOTE:
board.
Reverse this procedure to install the system board.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board (see
4. Remove the power connector cable
Remove the display assembly:
1. Disconnect the camera cable (1) and the antenna cables from the WWAN module (2).
54 Chapter 6 Removal and replacement procedures for authorized service provider parts
When replacing the system board, be sure to leave the RTC battery installed on the old system
(Bottom cover on page
(Preparation for disassembly on page
31).
Battery on page
(Power connector cable on page
31).
38).
44).