Lenovo L22e-30 User Manual page 17

Using the On-Screen Display(OSD) controls
To adjust the settings, the user controls can be viewed through the OSD.
Input Signal: VGA
To use the controls:
1. Press to open the main OSD menu.
2. Use or
function. If there is a sub-menu, you can move between options using
press to select that function. Use
3. Press to move backwards through the sub-menus and exit from the OSD.
4. Press and hold
adjustments to the OSD. Press and hold
adjustments to the OSD.
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold
disable / enable DDC/CI function. A message "DDC/CI disable" is shown on the screen.
L22e-30
Brightness
Contrast
DCR
Display Mode
Scaling Mode
Over Drive
to move among the icons. Select an icon and press
for 10 seconds to lock the OSD. This will prevent accidental
1920x1080
100
75
0
or to make adjustments then press
for 10 seconds to unlock the OSD and allow
Chapter 2.Adjusting and using your monitor 2-5
to access that
or , then
to save.
for 10 seconds to