Page 11 Attaching the center panel Page 12 Fitting the beams Page 13 Attaching the HDD cage Page 14 Fitting the motherboard tray Page 15 Fitting the side panels Page 16 Radiator placements Page 17 Troubleshooting Page 18 Page 1 XSpc...
Page 3
Introduction The XSPC H2 is a PC case specifically designed for high end PC watercooling. It can support a quad, single and triple 120mm radiator, while leaving plenty of space for tubing routing. The case is supplied in flat pack form, so you will need a little time and patience to get it set up correctly.
4 holes. sheet. Put a screw through each hole. On the underside of the panel Repeat the process for each of attach a washer and a nut to each the four castors. screw and tighten using a screwdriver. Page 7 XSpc...
Part 2: Preparing the Back Panel Put panel [B] on a flat surface Place panel [G] over panel [B] facing upward. and line up the six holes. Attach panel [G] using four 6-32 thumb screws. Page 8 XSpc...
Flip the panel over and thread the screwdriver due to limited space. power cables through the hole on the front. On the reverse side place an o- ring and nut over the switch then tighten the nut. Page 9 XSpc...
Use five 6-32 thumbscrews to Use a 6-32 thumbscrew to attach attach panel [O] to the back of the panel [O] to the base of the case. case. Page 10 XSpc...
Part 5: Attaching the Front Panel Take the prepared panel [A] and Use two countersunk screws in front panel [C] and slot the the two holes highlighted above. corners together. Repeat this for the two screw holes on the other side. Page 11 XSpc...
The HDD holes should be towards the front. Repeat step 3 on the opposite Lift the center panel and use a 6- side of the case. 32 countersunk screw on the left and right side of the panel. Page 12 XSpc...
HDD cage from under the center panel. You may wish to fit a fan to the A second optional HDD cage can front to provide HDD cooling. be added in the position shown. Page 14 XSpc...
6-32 thumb screws to position shown above. attach the motherboard tray. Attach the motherboard tray to the Use bracket [P] to attach the beam by using three 6-32 thumb motherboard tray to the center screws. panel. Page 15 XSpc...
Lay the case flat on its side, ready Start with the two screws shown for fitting the side panels. above and fit all sixteen 6-32 countersunk screws to panel [F]. Repeat this for the right panel [E] Page 16 XSpc...
Position2: You can mount a triple or quad 120mm or a triple 140mm radiator in the base of the case using a set of XSPC radiator brackets (sold separately). The base of the case has pre-drilled holes for the brackets.