Installation Condition - Jinko Solar JKM PP-60 Series Installation Manual

Scratches can appear on the module.
 Do not drill holes in the frame. It may cause corrosion of the frame.
 When installing modules on roof mounted structures, please try to follow the "from top to
bottom" and/or "from left to right" principle, and don't step on the module. This will damage
the module and would be dangerous for personal safety.

2.2 Installation Condition

2.2.1 Climate condition
Please install the modules in the following conditions:
a) Operating temperature: within –40° C(-40℉) to 85° C (185℉)
b) Humidity: < 85RH%
﹡Note: The mechanical load bearing (include wind and snow loads) of the module is based on
the approved mounting methods. The professional system installer must be responsible for
mechanical load calculation according to the system design.
2.2.2 Site selection
In most applications, Jinko solar PV modules should be installed in a location where they will
receive maximum sunlight throughout the year. In the Northern Hemisphere, the module should
typically face south, and in the Southern Hemisphere, the modules should typically face north.
Modules facing 30 degrees away from true South (or North) will lose approximately10 to 15
percent of their power output. If the module faces 60 degrees away from true South (or North),
the power loss will be 20 to 30 percent.
When choosing a site, avoid trees, buildings or obstructions, which could cast shadows on the
solar photovoltaic modules especially during the winter months when the arc of the sun is
lowest over the horizon. Shading causes loss of output, even though the factory fitted bypass
diodes of the PV module will minimize any such loss.
Do not install the PV module near open flame or flammable materials.
When solar modules are used to charge batteries, the battery must be installed in a manner,
which will protect the performance of the system and the safety of its users. Follow the battery
manufacturer's guidelines
recommendations. In general, the battery (or battery bank) should be away from the main flow
of people and animal traffic. Select a battery site that is protected from sunlight, rain, snow,
debris, and is well ventilated. Most batteries generate hydrogen gas when charging, which can
be explosive. Do not light matches or create sparks near the battery bank. When a battery is
installed outdoors, it should be placed in an insulated and ventilated battery case specifically
designed for the purpose.
concerning installation,
-4-
operation and maintenance