Huawei EchoLife HG8120 Series Quick Start Manual page 10

Configuring Wi-Fi Parameters
Step 1 Choose the WLAN tab and choose WLAN Basic Configuration.
HN8245Q is different from GPON terminal, Choose the Advanced Configuration >
WLAN tab and choose 2.4G Basic Network Settings. (If you want to configure 5G Wi-Fi,
choose 5G Basic Network Settings.)
Step 2 In the pane, select the Enable WLAN option box. In the dialog box that is displayed,
set the basic Wi-Fi parameters, including the SSID, authentication mode, and
encryption mode. For example,

SSID Name: WirelessNet (the name of a wireless network searched by the Wi-Fi
terminal)

Authentication Mode: WPA Pre-Shared Key

Encryption Mode: TKIP

WPA PreSharedKey: Password (the authentication password for the Wi-Fi terminal
to access a wireless network).
Step 3 Click Apply.
ONT supporting Wi-Fi, a wireless network coverage is subject to the number, thickness, and
positions of walls, materials, ceilings, or other objects that radio signals traverse. Besides,
material type and background radio frequency (RF) noise also affect the coverage of a
wireless network. You can maximize the coverage of a wireless network using the following
methods:
1. Decrease the number of walls and ceilings between ONT and other network
devices.
Each wall or ceiling reduces the coverage of a wireless network by one to 30 meters.
Install ONT at a proper place to avoid walls or ceilings whenever possible.
2. Observe the straight line rule when installing network devices.
The distance for which signals have to traverse at a 45° corner of two 0.5 meter-thick
walls reaches approximately one meter. To better receive signals, devices should be
installed at places where signals can directly traverse walls or ceilings.
3. Note the impact of building materials on the wireless network coverage.
A metal door or aluminum wall may limit the coverage of a wireless network. Install
access points, wireless routers, and computers, so signals can traverse walls or open
passageways. Materials and objects such as FRP products, metal products, insulative
walls, filing cabinets, bricks, and concrete weaken radio signals.
4. When connecting ONT to a wireless network, keep it far from the following
devices:

Electronic devices or components that produce RF noises (keep a distance of more than
2 meters between such a device and ONT.)

2.4 GHz wireless mobile phones or X-10 devices (such as microwave ovens, home
security systems, blue-tooth devices, and refrigerators) that greatly weaken or even
eliminate radio signals. Even if a 2.4 GHz wireless mobile phone is not connected to a
wireless network, the phone base still sends signals that interfere the wireless network.
5. In order to avoid the possibility of exceeding the Europe radio frequency
exposure limits, human proximity to the equipment shall not be less than 20 cm.
10