Advertisement
STEP 1 – Frame Layout
Check that you have received all parts using the relevant illustrations below. These
illustrations are a general instruction. All parts with the same part are interchangeable and
do not have "right" or "left" orientation, To connect the parts, simply slide a section of
tubing into the adjacent section. These joints are called "T shape section".
The rectangle trampoline consists of the following parts:
I. T-shape section (nr.4)
II. Toprail (nr. 3)
III. Legbase (nr. 5)
Put the different pieces together as shown in figure 1.
IMPORTANT - It is essential that the intended site for this trampoline is completely
flat and level. If the ground is un-level this will cause movement in the frame and
could cause stress on the joined sections.
Figure 1
11
Advertisement
