Introduction; System Components - YZ Systems DynaPak 2010XN System Manual

1. Introduction

Congratulations on your purchase of the DynaPak
2010 Series Sampler. You've made a wise
measurement investment for your company.
Before you begin installation, insure that all of the
necessary components are present. You will need
a sample cylinder(s) during the installation. If you
have questions concerning installation/operation,
contact your YZ representative or YZ Customer
Service at 936.788.5593.

2. System Components:

The primary components of the DynaPak 2010
Sampling System are illustrated here.
Z-65 Controller
Factory
Mutual
System
Approved
DP-2010X
YZ SYSTEMS, INC.
3101 POLLOK CONROE, TEXAS 77303
Patents 5,152,678; 4,531,895; 4,928,536
Note: Wiring and Pneumatic Tubing Not
Shown For Drawing Clarity
YZ Systems, Inc. • 3101
DP-2010XN Version 08222001 ATEX Rev.
Cable Entry Fitting
1949
Filter/Regulator
Pollok Drive • Conroe,
Solenoid Valve
8 1/2" (22 cm)
8 1/2" (22 cm)
Sample Inlet
Texas • USA • 77303
10 1/2" (27 cm)
10 1/2" (27 cm)
DynaPak 3000 Pump
DynaPak 2000N Pump
Sample Discharge
Tubing
Sample Discharge
Purge Valve
Isolation Valve
Probe Body Assembly
1/2" NPT
3/4" NPT
• P: 936.788.5593 • F:
3
936.788.5720