Outland Living TTCK 102 Manual page 6

Conversion kit
Table of Contents

Advertisement

PORTABLE PROPANE
TONGA TORCH
SECTION 2:
SET UP
IMPORTANT:
• Always ensure the Tonga Torch stands straight and vertical.
• The Tonga Torch is meant to be deployed on level ground.
In the event of uneven ground adjust the fixed angle of the
legs.
• It is recommended to use large flat rocks to level the
appliance if the ground is very uneven.
Insert Torch
Top into
Base Tube
Deploy Legs
and stand
Tonga Torch
straight
Unwind any
twists or kinks in
the gas hose
Stake Holes
(up to 8mm Ø)
Stakes not included
En-5
OUTLAND LIVING PORTABLE PROPANE TONGA TORCH - CONVERSION KIT OWNER AND SAFETY MANUAL
Conversion Kit
Owner and Safety Manual
Lock down
the tube
collar clamp
Tighten
the nuts
SECTION 3:
APPLIANCE INSPECTION &
TEST SEQUENCE
Each time the appliance is put to use, and prior to ignition,
conduct the following appliance inspection and test
sequence:
• Ensure all joints are firmly fastened and the appliance is
standing straight.
• Inspect the hose prior to each use. The hose assembly
must be replaced prior to the appliance being put into
operation if there is evidence of excessive abrasion or
wear, or if the hose is damaged. Contact FMI Brands Inc.
should you require a replacement hose.
• Inspect the mid-point gas connection (sealed gas fitting)
prior to each use. Check the fitting is firm and the seal
is not broken or damaged. WARNING: Removal of the
sealed gas fitting and/or seal is not permitted for safe
operation and may affect warranty or claims.
• Inspect the burner prior to each use. Ensure all holes are
clear and there are no leaves, pine needles, spider webs
or other debris in burner area. Burner must be replaced
prior to the appliance being put into operation if there is
evidence of damage. Replacement parts such as burners
are available from FMI Brands Inc.
• Ensure the proper gas connections are made. See
section labelled "Connection".
• Leak Test all connections. See section labelled "Leak
Test".
• Ensure that the LP gas cylinder and gas hose is placed
in an area where it is unlikely to be tripped over (such
as pathways or trails) or subject to other accidental
damage.
D.772.000.V1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ttck 103

Table of Contents