Table of Contents
Advertisement
SECTION 1:
CONVERSION (continued)
STEP 5
Carefully cut and
remove the black
heat shrink seal
without cutting the
tubing.
STEP 6
Unscrew the appliance
gas hose threaded
coupling from the mid-
point gas connection
with two wrenches.
Use 5/8" (17mm) and
Hold firm
3/4" (19mm) wrenches.
(Use 5/8" (17mm) wrench)
STEP 7
Remove and set aside the 3.048 m / 10 ft gas hose.
STEP 8
Use the mounting screws provided to mount the 1lb LP cylinder
holder onto the bottom of the Tonga Torch base where the two
screw holes are located.
1lb Propane Cylinder
Holder & (2x)
Mounting Screws
STEP 9
Insert the new
0.32 m / 12.6" gas
hose threaded
coupling through
the gas hose hole,
located on the Tonga
Torch base.
Turn Counter Clockwise
(Use 3/4" (19mm) wrench)
STEP 10
Connect the gas hose threaded coupling to the mid-point gas
connection. Use two wrenches to firmly tighten.
CAUTION:
Take care not to cross thread the connection!
STEP 11
Prior to ignition, follow proper set up, connection, leak test and
ignition procedures.
STEP 12
Your Outland Living Portable Propane Tonga Torch is now
converted. Follow normal lighting procedures as per your
owner's manual.
SECTION 2:
SET UP
STEP 1
Insert Tonga Torch top into base tube.
STEP 2
Deploy legs. Stand the Tonga Torch straight. Tighten the nuts.
STEP 3
Unwind any twists or kinks in the gas hose. Ensure the hose is
straight.
STEP 4
Lock down the tube collar clamp.
Note: unwinding clamp counter clockwise will loosen clamp
force; winding clamp clockwise tightens clamp force.
Important adjustment points:
a. Legs: Tighten the nuts. Always ensure the torch
stands straight and the leg joints are firmly set.
b. Tube Collar Clamp: Always ensure the tube collar
clamp is tightly locked in position.
1-888-514-1663 |
WWW.OUTLANDLIVING.COM
En-4
Advertisement
Table of Contents
