Uwatec Nova 850R Manual

SCUBAPRO NOVA 850R GUIDE
Thank you for purchasing the Nova 850 dive light from SCUBAPRO. This rugged light features a high intensity LED. It uses one
standard 18650 rechargeable battery and has a burn time of up to 2 hours (depends on battery type and quality).
Nova 850R WIDE technical specifications
Light source
Color temperature
Rated output
Beam Angle
Battery cell type
Number of cells
Run time
Diameter
Length
Weight
Waterproof depth
Approx. lifetime of bulb
* Luminous flux (lumens) / Lux output are measured when switching on with a fully charged accumulator / new set of fresh alkaline
batteries. The measures are average values and may vary +/- 15% depending on the type of chip and batteries used.
INSTRUCTIONS
Make sure to not over tighten the casing as this could result in premature wear and/ or damage to the O-rings.
*NEVER USE A TOOL OF ANY KIND TO TIGHTEN THE CASE*
To turn ON the SCUBAPRO Nova 850 un-lock the light first by quickly pressing the button 5 times within 3 seconds until the blue
standby-indicator light is turned on. Then press the button for half second and the light turns on. To switch from 100% to 50% mode
press the button once. Pressing the button again will turn off the light and the blue standby- indicator lights is turned on again. To
lock the Nova 850 for storage or travel quickly press the button 5 times or more within 3 seconds during standby.
Battery selection:
We recommend using only high-quality batteries. Low quality batteries can cause off-gassing and damage to the internal electronics.
The light is fitted with an overpressure valve for your safety. In case the battery produces gas leading to a high internal pressure of
the light, the valve will open. This may cause water to enter the light.
! WARNING
Do not look directly into the light or direct the light into the eyes of others. Do not alter or modify the dive light. If modification
causes water entry or other malfunctions, the warranty will be void.
Proper storage: if the dive light is not to be used for a long period of time, remove batteries to avoid accidental leakage.
Proper maintenance: frequent use of the dive light may cause O-rings to dry out. To avoid leakage, clean O-ring groove with a
cotton swab and regularly apply lubricant to O-rings to help prevent dry cracking. Please rinse the Nova 850 with fresh water before
storing.
Environmental protection / disposal instructions:
Dispose of this product only at a specific collection point for electrical refuse. Batteries do not belong in household waste!
Please dispose of batteries and/or the dive light in appropriate collection facilities. SCUBAPRO Nova 850 - Warranty
All warranty claims must be returned with dated proof-of-purchase to an Authorized SCUBAPRO Dealer. Visit www.scubapro.com
for the dealer nearest you.
Warranty does not cover:
- Loss.
- Defects, damage or deterioration due to normal use or wear and tear.
- Damage caused by exposure to excessive heat, prolonged sunlight or corrosive chemicals.
- Damage due to poor maintenance, improper use, alteration, negligence or accident.
- Damage due to repair by someone other than SCUBAPRO or an Authorized SCUBAPRO Dealer.
European Union markets: the warranty of this product is governed by European legislation in force in each EU member state.
Disposal of Waste Electrical and Electronic Equipment in the European Union. EU Directive 2002/96/EC and
EN50419. Please dispose of this product at an appropriate collection point to help protect the environment.
1 x CREE XP-L LED
6000° K
up to 850 Lumens *
80°
18650
1
up to 2.0 hours
44.6 mm / 1.7 inches
153 mm / 6.0 inches
231 grams / 8.1 ounces without batteries
150 meters / 490 feet **
50,000 hours