Preparing To Fill Your Water Bath; Filling Your Water Bath; Preparing To Turn "On" Your Water Bath; Turning "On" Your Water Bath - Whitehall SP-1600-A-B Instructions For Operation And Care Of

Instructions for Operation and Care of Water Bath SP-1600-A-B

4. Preparing to Fill your Water Bath

Make sure appliance is unplugged and all packaging has
been removed from reservoir. Ensure that the inside of
tank is thoroughly clean before filling with water.
DO NOT use any medium except water.
Check drain valve and make sure handle is in the
"closed position" by turning clockwise to make certain no
water in tank will drain out of appliance while being filled.

5. Filling your Water Bath

Appliance must be unplugged. Fill appliance with water
to line labeled "FILL TO LINE", which is located
inside tank side.
Note: We recommend the use of
distilled water to reduce the build-
up of mineral deposits and dirt.
FILL TO LINE

6. Preparing to turn "ON" your Water Bath

Close lid.
Caution! Lid can pinch fingers.
Locate the Power Switch at front of the appliance and
make sure it is set to "OFF" (the switch will not be lit).
Insert connector end of power cordset into power inlet at
side of appliance.
Connect plug end of power cordset into a G.F.C.I.
protected AC electrical receptacle.

7. Turning "ON" your Water Bath

You are now ready to turn "ON" the appliance. Locate
the Power Switch at the front of the unit and press to
"ON" position causing the switch to light.
| ON
O OFF
4
WHITEHALL MANUFACTURING • P .O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
SET-UP INSTRUCTIONS
Ball valve closed
(continued)

8. Changing the temperature on your Water Bath

Your water temperature is adjustable and can be set to
reach splint materials recommended operating
temperature. (See splint manufacturer's instructions.)
Note: Most splint material on the market today, has an
operating range between 113°F (45°C) to 200°F (93°C).
Your Water Bath is capable of approximate maximum
temperature of 200°F (93°C), depending on amount of
water in unit.
Note: Thermal Overheating Sensor is set to shut down
unit at temperatures of 215°F (102°C) and above.
(Caution: Unit will automatically turn back on once the
temperature has dropped to lower temperature.)
The thermostat is very sensitive, even a small
adjustment can raise or lower the temperature several
degrees. To adjust the temperature, turn black knob at
the lower right hand side of unit:
TO RAISE TEMPERATURE
When raising temperature, allow the temperature to
stabilize and read the water temperature on the digital
thermometer above the knob. Keep lid closed while unit is
heating up.
When lowering temperature, allow the temperature to
stabilize and read the water temperature on the digital
thermometer above the knob. Keep lid open while unit is
cooling down.
WARNING WARNING
! !
Use the Water Bath only as directed in this manual.
Any other use can cause injury.
TO LOWER TEMPERATURE