Adjusting The Tracking; Checking The Tire Pressure - Toro Z Master Professional 5000 Series Operator's Manual

1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between fast and slow.
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
•
If it tracks to the right, loosen the bolts and
adjust the left stop plate rearward on the
left T-slot until the machine tracks straight
(Figure 62).
•
If it tracks to the left, loosen the bolts and
adjust the right stop plate rearward on the
right T-slot until the machine tracks straight
(Figure 62).
Figure 61
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-L
EUTRAL
6. Tighten the stop plate
g021420
1. Control lever
2. Bolt

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
Maintain the air pressure in the front and rear tires at
90 kPa (13 psi). Uneven tire pressure can cause an
uneven cut. Check the tires when they are cold to get
the most accurate pressure reading.
OCK
54
(Figure 62).
Figure 62
Left control lever shown
3. Stop plate
comes first)
Figure 63
g027424
g001055