Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Second Wind 2412-FC
Summary of Contents for Second Wind 2412-FC
- Page 1 24V Coil Clean Installation Manual RARE EARTH MAGNETS F/ EZ-BEND FOR UNDER-COIL FAST INSTALLATION INSTALLATION Electric Drill Tape measure Phillips screwdriver Aluminum tape & sealant Tin snips Multimeter Eye protection Hex Driver Rev 7 Issued: 02/12/2019...
- Page 2 Check damaged parts: Before further use of the unit, any damaged part should be carefully checked to ensure that the unit will operate properly. Any part that is damaged should be properly repaired or replaced. Always service unit with Second Wind replacement parts & recommended accessories (i.e. lamps, ballast). CAUTION: Disconnect power before starting installation or maintenance.
- Page 3 If the lamp is broken read the ‘Lamp Disposal’ section of this manual. The Second Wind Ultraviolet Germicidal Photo-catalytic 24 Volt Lamp is designed for 9000-11,000 hours of continuous operation. After 9000 hours intensity of the lamp inside the duct diminishes and should be replaced.
- Page 4 Your new Second Wind Air Purifier must be properly installed, operated and maintained in accordance with the unit installation, operation, and This warranty will be voided if the covered equipment (only Second Wind replacement parts or units are warranted) is removed from the original installation site.
Need help?
Do you have a question about the 2412-FC and is the answer not in the manual?
Questions and answers