Installation Procedure - Toto EcoPower Series Installation And Owner's Manual

NOTE: For retrofit installation, remove the old Flush Valve after shutting off the
control stop.
1. Install the control stop using an
appropriate size escutcheon and a
sweat solder adapter kit, if applicable.
Thread sealing compounds should be
used on male NPT threads only.
The distance from center of the control
stop to center of the Flush Valve
should fall within 4-1/4" to
5-1/4"(107mm to 133mm).
For use with a left water supply, attach
the sensor top cover in the opposite
direction so that the sensor will be at
the front.
2. Determine the length of vacuum
breaker tube to join the Flush Valve
and fixture spud. If required, cut the
vacuum breaker tube to the proper
length.
3. Assemble the spud nut assembly to
the fixture spud. Hand tighten spud
nut to fixture.

INSTALLATION PROCEDURE

For sweat solder
Min.4-1/4"(107mm)
Max.5-1/4"(133mm)
Control stop
Right Water Supply
7
Escutcheon
Covering tube
Adapter
Left Water Supply
Friction washer
Vacuum breaker
Tube nut
Spud nut
Slip gasket
Rubber gasket
Escutcheon