Advertisement
Sunlight film Installation
1. Insert sunlight film tab 'A' into 'B' position.(Repeat same on opposite side)
1
※When installing the sunlight film, be sure to have it slided behind
the tap 'B' holder.
Opening Chin Bar
1. To open the chin bar, simply pull the lever forward and push the entire bar upward.
2. The chin bar is in the full open position when you hear " click" sound.
To maximize helmet's ability to protect, we highly recommend to ride with the chin bar in
closed position. In the event a rider rides with the chin bar open, there is an increased risk
of injury to the frontal area. Do not raise or lower the chin bar while riding. This may
interrupt rider's ability to control the motorcycle and may lead to an accident.
Please use care when opening or closing the chin bar as it may scratch the helmet.
Damage caused by this is not subject to manufacturer's warranty.
Closing Chin Bar
When the shield is open and the chin bar is raised and lowered to a lock position, the shield may not be
in a latched position with the chin bar. Before riding, please make sure that the shield is latched with
the chin bar securely. (Center closure system)
Pull the chin bar downward to completely cover your face and chin. Listen for "click" sound to ensure
that the chin bar has locked into its full closed position.
11
Replacement Parts
Always check to make sure helmet pads are installed before using the helmet. A helmet with missing or improperly installed
pads may increase your risk of serious injury or death in an accident.
Do Not Modify Your Helmet
Your HJC helmet is designed to meet ECE R 22-05 standard. Contact HJC Europe for more information about the ECE R 22-05
standard. Modifying your helmet may increase your risk of serious injury or death in an accident. Do not modify your HJC
helmet. Modifications include the following :
• drilling holes;
• cutting shell, liner, or strap;
• modifying the retention system, including adding a chin cup;
• removing parts;
• painting; and
• attaching accessories that are not manufactured by HJC for this helmet.
If you have questions about modifications, please contact HJC, See back cover for contact information.
Storing Your Helmet and Shield Correctly
An improperly stored helmet and shield can become damaged and may increase your risk of serious injury
or death in an accident. You should:
• Store helmet and shield in a cool and dry place,
• Keep helmet and shield away from pets and other animals,
• Keep helmet and shield away from heat in excess of 50°C and do not set on or near hot surfaces.
• When helmets left out in the sun for extended periods of time, it may fade overtime.
Helmet Replacement
Although your HJC helmet is constructed with the best materials available to offer a long-lasting product, it
will eventually need to be replaced. Immediately replace your helmet if:
• It has suffered an impact. Your helmet is only designed for ONE impact. An impact may fracture the outer
shell or compress the impact absorbing liner. You may not be able to detect this damage. Any impact in
a crash or a drop from as low as 4 feet is enough to damage your helmet.
• The shell, lining, or retention system is damaged. The helmet shell, the impact absorbing lining, and the
retention system must be in good condition to provide you with the most protection.
Even if your helmet has not been damaged, it needs to be replaced every 3 to 5 years depending on how much you use it.
Over time, UV rays and adhesive and component aging will damage your helmet. Wearing a damaged helmet may increase
your risk of serious injury or death in an accident. If you are unsure if you need to replace your helmet, contact HJC Europe
before using your helmet again.
Helmet Disposal
If you buy a new helmet, destroy the old one to ensure it cannot be reused. Do not sell or give away your
old helmet, even if it has not been damaged. Over time the protective foam in the helmet will adjust to the
contours of your head. If someone else uses this helmet it will not provide them with as much protection.
Warranty
HJC hereby extends a limited warranty to the purchaser of a HJC helmet that the helmet is free of defects in materials and
workmanship.
Coverage
This warranty is applicable to manufacturer's defects only and the warranty period varies between HJC models. The RPHA
Series warrants up to 5 years from the date of purchase or 7 years from date of manufacture, while all other models warrant
up to 3 years from the date of purchase or 5 years from date of manufacture (whichever comes first). This warranty does
not apply to any problems that arise from wearer's misuse, negligence, modifications, accidents, etc. A change of fluorescent
color is not subject to warranty as this is a typical characteristic of fluorescent color; it may fade or degrade depending on the
user's environment.
Disclaimer
Any warranty of merchantability and any implied warranty are hereby expressly disclaimed. In addition HJC shall not be liable
for any consequential damages.
Procedure
In order to receive warranty, please take your helmet, your receipt showing the date of purchase, and a brief memo that
includes a description of the problem, your name, and phone number tothe authorized HJC dealer from which you purchased
your helmet.
12
Advertisement
