Operational Details; Dim And Mute Functions; Auto-On Function - Benchmark DAC3 DX Instruction Manual

Operational Details

DIM and MUTE Functions

Definition: If the DIM and MUTE and
COMPATIBILITY modes are all off, the
DAC3 DX is in NORMAL mode.
DIM Function
The DIM function reduces the output level by
20 dB. To toggle between NORMAL and DIM
volume, press the DIM button on the remote
or the DIM button on the front panel.
The DIM light will turn on whenever DIM is
active.
The DIM function makes it convenient to fade
back and forth between normal and
background playback volume levels.
If the volume is adjusted while DIM is active,
the NORMAL volume setting will change by
the same amount.
If an output bus is set to CALIBRATED
mode, DIM is disabled on that bus.
TIP: In the studio, the DIM function allows a
temporary reduction in level without losing
the volume setting that was being used for
monitoring.
Tip: In home applications the DIM function
allows temporary reductions in volume during
TV commercial breaks, phone calls, or other
interruptions, without losing the volume
setting that was being used for normal
listening.
MUTE Function
The MUTE function immediately mutes all
outputs. To toggle this function, press the
MUTE button on the remote or press the
MUTE button on the front panel.
The MUTE light will turn on whenever MUTE
is active.
Instruction Manual for DAC3 DX with
Tip: If the unit is in MUTE, press the DIM
key to immediately enter the DIM mode.
Tip: If the unit is in MUTE and/or DIM press
the ON key (on the remote) to enter the
NORMAL mode.
Tip: if the unit is in DIM, press the MUTE
key to toggle between DIM and MUTE.

AUTO-ON Function

The DAC3 DX can be programmed to
automatically turn on whenever AC power is
applied. This function allows automation using
switched AC outlets. When AUTO-ON is
enabled, the DAC3 DX cannot be turned off
without removing AC power.
The AUTO-ON function is programmed by
pressing and holding the POWER button on
the front panel for 10 seconds. It is the only
function that cannot be programmed from the
remote control. This limitation prevents
accidental access to this special feature.
Enabling AUTO-ON
Starting with the DAC3 DX off, press and
hold the POWER button for 10 seconds.
If AUTO-ON has been successfully enabled,
the POWER button will now function as a
MUTE button. The OFF button on the remote
will also function as a MUTE button when
AUTO-ON is enabled.
Disabling AUTO-ON
Starting with the DAC3 DX on, press and
hold the POWER button for 10 seconds. At
the end of 10 seconds the DAC3 DX will
power down if the AUTO-ON mode has been
successfully disabled.
2.X Firmware - Rev. B Page 16