Getting Started; Baby Unit Power Supply; Parent Unit Power Supply - Kodak Cherish C525 User Manual

2. GETTING STARTED

2.1 Baby Unit Power Supply

The Baby Unit comes with a built-in Li-ion battery.
Charging the rechargeable battery pack fully before use
is recommended. This will allow the unit to operate on
battery in the event of a power failure.
1. Insert the small end (USB) of the Baby Unit's power
adapter (Output 5V, 1500mA) into the USB socket
in the back of the Baby Unit.
2. Insert the other end of the power adapter into a
suitable electrical outlet.
3. Slide the ON/OFF switch to the ON position to
switch on the Baby Unit. The power indicator lights
up in blue.
4. Slide the ON/OFF switch to the OFF position to
switch off the Baby Unit. The power indicator
lights up in red, indicating that the battery is being
charged.
*IMPORTANT: Only use the supplied power
adapter.*
Page | 18

2.2 Parent Unit Power Supply

The Parent Unit comes with a built-in Li-ion battery.
Charging the rechargeable battery pack fully before use
is recommended. This will allow the unit to operate on
battery in the event of a power failure.
1. Insert the small end (USB) of the Parent Unit's
power adapter (Output 5V, 1500mA) into the
USB socket in the back of the Parent Unit.
2. Insert the other end of the power adapter into
a suitable electrical outlet. The battery status
indicator will light up in red to indicate that
the Parent Unit is connected to the electrical
outlet.
*IMPORTANT: Only use the supplied power
adapter.*
3. Slide the power ON/OFF button that is located
on the side of the Parent Unit to switch on the
device.
4. When the Baby and Parent Units are both
switched ON, the display on the Parent Unit
will show the image captured by the Baby
Unit. If the Baby Unit (camera) is not in range
or is switched off, the Parent Unit beeps
repeatedly and an error message will appear
on the screen.
Getting Started