Led Definitions; Hardware Reset; Microsd/Sdhc/Sdxc Card Capacity; Network Deployment - Cisco 8620 Reference Manual

LED Definitions

LED Definitions
Table 1-1
Table 1-1
Item
1
2
3
4
5

Hardware Reset

The recessed button (see
used to reset the system or restore the factory default settings. Sometimes resetting the system can return
the camera to normal operation. If the system problems remain after reset, restore the factory settings
and install again.
•
•

MicroSD/SDHC/SDXC Card Capacity

The camera is compliant with SD/SDHC/SDXC 16GB / 8GB / 32GB / 64GB and other preceding
standard SD cards.

Network Deployment

The following sections provide information about deploying the camera on a network:
•
•
Cisco Video Surveillance 8620/8630 IP Camera Reference Guide
1-20
describes the LEDs on the Cisco Video Surveillance IP Camera.
IP Camera LEDs
LED Status
Steady red
Red LED off
Green LED off
Steady Red and Green LED blinks every 1
sec.
Green LED blinks every 1 second and red
LED blinks consecutively every 0.15 second
Green and red LEDs blink every 0.15 second,
green and red light on, then blink again
Red LED is on, green LED blinks, and red
LED is constantly on
Green and red LEDs are constantly on
Figure 1-2 on page 1-3
Reset—Press the recessed reset button. Wait for the camera to reboot.
Restore—Press and hold the reset button until the status LED rapidly blinks. All settings will be
restored to factory default. Upon successful restore, the status LED will blink green and red during
normal operation.
General Connection (PoE), page 1-21
Network Connection, page 1-22
Description
Powered and system booting, or network
failed
Power off
Network disconnected
Connected to network
Upgrading firmware
Restoring defaults
Status after a reset (network connected)
Status after a reset (network disconnected)
for the 8620 or Figure 1-4 on page 1-4
Chapter 1 Getting Started
for the 8630) is