Additional Cli Commands For The Fortiusb Key - Fortinet FortiGate FortiGate-5000 Firmware And Fortiusb Manual

The FortiUSB key
3
4
5
1
2

Additional CLI commands for the FortiUSB key

FortiGate-5000 Series Version 3.0 MR4 Firmware and FortiUSB Guide
01-30004-0383-20070201
Select the following:
• On system restart, automatically update FortiGate configuration file if default
filename is available on the USB disk.
• On system restart, automatically update FortiGate firmware image if default
image is available on the USB disk.
Enter the configuration and image filenames or use the default configuration
filename (fgt_system.conf) and default image name (image.out).
Select Apply.
To configure the USB Auto-Install using the CLI
Log into the CLI.
Enter the following command:
config system auto-install
set default-config-file <filename>
set auto-intall-config <enable/disable>
set default-image-file <filename>
set auto-install-image <enable/disable>
end
Use the following CLI commands when you want to delete a file from the FortiUSB
key, list what files are on the key, including formatting the key or renaming a file:
•
exec usb-disk list
•
exec usb-disk delete <filename>
•
exec usb-disk format
•
exec usb-disk rename <old_filename1> <old_filename2>
Note: If you are trying to delete a configuration file from the CLI command interface, and
the filename contains spaces, you will need quotations around the file name before you can
delete the file from the FortiUSB key.
Additional CLI commands for the FortiUSB key
21