Advertisement
transferring image and voices if PIR sensor is still under
triggered condition. Otherwise, the camera will send an
"OFF" signal to the receiver and shut down images and
voices.
(4) When PIR of the camera is triggered, the camera will send
2.4GHz RF signal to the receiver. Thus, images and voices
will be displayed on TV or monitors through the receiver.
(5) When battery is low:
a. In the condition of camera on, Camera sends a signal to
the receiver to lighten the "Battery" LED and sound two
"beeps" for alert.
b. If battery is low during image transmitting, the image will
stay on for 5 seconds only. Then there will be two beeps
and the "Battery" LED will be on.
(6) If the camera battery is recharged to normal level, the low
Battery LED will be turned off when the camera is
triggered again.
You can also additionally have a 9V DC 300mA regulator power
AC adapter and wire it on S3 (refer to Figure 3) of backplate to
recharge and to transmit images and voices continuously.
Note:
(1) What you should do when the camera does not work
properly:
a. Unscrew the camera (two screws on the edge of front cover)
b. Press "SW1" on Wall Mount to restore the system
c. Turn off the receiver, then turn it on.
d. Hang the camera on Wall Mount, and tighten 2 screws on
the bottom of the camera.
(2) When battery is low, video automatically reduces to 5
seconds to save battery.
(3) Position the receiver and set up channel first while installing,
then position the camera and set receiver in the same
channel with the camera.
(4)When the image on TV is not clear, it means that somebody
may use the same channel as yours in your neighborhood.
You can change both channels on the backplate of camera
and the receiver. Remember to set the camera in the same
channel as that of the receiver.
3
Advertisement
