Advertisement
h.
In order for the Remote Control to operate with the Camera
both devices must be configured with the same 'House
Code'.
The House Code is configured by setting the 8 DIP switches,
located on the PCB in the rear of the main camera body, to a
random On/Off sequence. Use the tip of a ballpoint pen or
a small screwdriver to move each switch in turn and ensure
that each switch 'clicks' fully into position.
Note: it is recommended that the system House Code is
always reset to a code other than the factory default.
ON
1
2
3
4
SW1
Step 2: Install Receiver Unit
(Two visions available: European and American)
European Version (refer to Figure 6):
To connect receiver to your TV:
1. Plug the 1M Scart connector cable that
package included into your TV.
2. Plug the other end, yellow (video), white (audio) and red
(trigger) RCA connectors into the corresponding RCA
connectors on the receiver.
Figure 6 European Version
American Version (refer to Figure 7):
ECE
5
6
7
8
To connect receiver to your TV:
1. Plug the yellow (video) and white (audio) RCA connectors
into TV socket.
2. Plug the yellow (video) and white (audio) RCA connectors
into the corresponding RCA connectors on the receiver.
Figure 7 American Version
Step 3: Install Remote Control
1. Remove the battery cover fixing screw on the rear of the
Remote Control and carefully remove the front
2. Ensure that the House Code setting of the DIP switches in
the Remote Control are set to the same On/Off sequence
as set on the Camera.
3. Insert the battery taking care to observe the correct polarity.
4. Replace the front cover and refit the fixing screw. Do not
over tighten the screw as this could damage the screw
thread in the moulding.
Operating Instruction:
(1) Buzzer/Light ON/OFF SW: Select "Buzzer/Light SW" at
"ON". When PIR camera is triggered, image and voices
will be transmitted. Upon receiving the signals, the receiver
sounds "Beep" twice in response and the LED will flash for
1 minute.
(2) Transmission time (lock time) of image and voices can be
set as 10, 20, 30, or 40 seconds by carefully adjusting the
"DWELL_SW (SW3)" knob of Camera.
(3) When lock time of trigger is over, the camera will continue
2
cover.
Advertisement
