Replacing Fuel Light Batteries - Champion 100414 Operator's Manual

100414 - 2000W PORTABLE INVERTER GENERATOR
3. Remove the clamp(C) and cap(B) which retain the spark
arrestor(A) to the muffler.
4. Remove the spark arrestor screen.
5. Carefully remove the carbon deposits from the spark arrestor
screen with a wire brush.
6. Replace the spark arrestor if it is damaged.
7. Position the spark arrestor on the muffler and attach by
reversing the steps from above.

Failure to clean the spark arrestor will result in degraded
engine performance.

Federal and local laws and administrative requirements
indicate when and where spark arrestors are required. When
ordered, spark arrestors are required for operation of this
generator in National Forest lands. In California, this generator
must not be used on any forest-covered land, brush-covered
land, or grass-covered land unless the engine is equipped with
a spark arrestor.

Replacing fuel Light Batteries

1. Use a small screwdriver to disassemble the upper cover.
B C
A
CAUTION
NOTICE
There is a notch on both sides to allow access with a
screwdriver.
2. Move the round copper cover plate and remove the battery
cells.
3. Keep the small spring attached to the copper pillar and place
the compressed spring back into the bottom of the assembly.
The compressed spring will have the small end facing outward.
4. Place new battery cells (2 × LR1130) back into the assembly
with negative (−) pole facing upwards and positive (+) facing
towards the compressed spring. Move the round copper cover
plate to cover and touch the button cell.
22
MAINTENANCE
NOTICE

NOTICE
