Table of Contents
Advertisement
Safety and operating instructions
No person who is under the influence of drugs,
►
alcohol or medication may operate the
machine.
Installation, precautions
WARNING Ejected working tool
If the tool retainer on the machine is not in a locked
position, the working tool can be ejected with force,
which can cause personal injury.
Always stop the machine before changing the
►
working tool or accessories.
Never point the working tool at yourself or
►
anyone else.
Make sure that the working tool is fully inserted
►
and the tool retainer is in a locked position
before the machine is started.
Check the lock function by pulling the working
►
tool outwards powerfully.
WARNING Moving or slipping working tool
An incorrect dimension of the working tool's shank
can result in that the tool is lost or is slipping out
during operation. Risk of severe injury or crushed
hands and fingers.
Check that the working tool has the shank
►
length and dimensions that the machine is
intended for.
Never use a working tool without a collar.
►
Operation, precautions
WARNING Overheating hazard
The machine may overheat if the cooling air inlet is
covered. This can cause serious damage to the
machine and/or the operator.
Never block or cover the cooling air inlet.
►
DANGER Explosion hazard
If a warm working tool or exhaust pipe comes into
contact with explosives, an explosion could occur.
During operating with certain materials, sparks and
ignition can occur. Explosions will lead to severe
injuries or death.
Never operate the machine in any explosive
►
environment.
Never use the machine near flammable
►
materials, fumes or dust.
Make sure that there are no undetected
►
sources of gas or explosives.
6
Avoid contact with the warm exhaust pipe or the
►
bottom of the machine.
DANGER Fuel hazard
The fuel is extremely flammable and petrol fumes
can explode when ignited, causing serious injury or
death.
Protect your skin from contact with the fuel. If
►
fuel has penetrated the skin, consult a qualified
health professional.
Never remove the filler cap, and never fill the
►
fuel tank when the machine is hot.
Always fill the fuel (environmental petrol also)
►
outdoors or in a well ventilated place.
Mix the fuel and fill the fuel tank outdoors or in a
►
clean and well ventilated place, free from
sparks and open flames. Fill the fuel tank at
least ten meters (30 feet) from the place where
the machine is to be used.
Release the filler cap slowly to let pressure
►
escape.
Never overfill the fuel tank.
►
Make sure the filler cap is screwed on when the
►
machine is used.
Avoid spilling fuel on the machine, wipe off any
►
spilled fuel.
Check regularly for fuel leaks. Never use the
►
machine if it is leaking fuel.
Never use the machine in the proximity of
►
material that can generate sparks. Remove all
hot or spark-generating devices before starting
the machine.
Never smoke when filling the fuel tank or when
►
working with the machine or servicing it.
Only store fuel in a container that is specially
►
constructed and approved for the purpose.
Consumed petrol and oil containers must be
►
taken care of and returned to the retailer.
Never use your fingers to check for fluid leaks.
►
WARNING Unexpected movements
The working tool is exposed to heavy strains when
the machine is used. The working tool may break
due to fatigue after a certain amount of use. If the
working tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or
slipping may cause injury.
Make sure that you always keep a stable
►
position with your feet as far apart as your
shoulder width, and keeping a balanced body
weight.
© Atlas Copco Airpower | 9800 1629 01 | 2018-01-01
COBRA TTe
Original instructions
Hide quick links:
Advertisement
Table of Contents
