Display - Miele G 6892 Operating Instructions Manual

Display

General
The display is used to select or set the
following:
– the programme
– the FlexiTimer (Delay start)
– the Settings menu
The display can show the following:
– the stage the programme is at
– the estimated time left for the
programme to run
– the energy and water consumption
(EcoFeedback)
– any relevant fault messages and
information
To save energy, the dishwasher
switches off after a few minutes if you
do not press any buttons during this
time.
To switch the dishwasher back on
again, press the  button.
Guide to the appliance
Settings menu
The Settings menu is used to alter the
dishwasher's electronics to suit
different requirements. You access the
Settings menu by pressing a specific
button combination (see "Settings
menu").
The arrows in the display indicate
further options. You can use the
 arrow buttons next to the display,
as appropriate, to select these further
options.
The OK button is used to confirm a
message or setting and also to move to
the next menu or another level.
The option which is selected will have a
tick  next to it.
To exit a sub-menu, use the  arrow
buttons to select the
the display and confirm your selection
with OK.
If you do not press any of the buttons
for several seconds, the display will
return to the previous menu level. You
may need to enter your settings again.
Back  option in
7