Filter Maintenance - Zenith HydroTap G4 User Manual

LCD Screen operation - Section G
Dispense Times
Water Filter
The Zenith HydroTap notifies when filter replacement is due. If you notice
one of the following, you will need to change the filter:
• The Change Filter light will flash white once a second and remain so until
reset.
• The filter percentage will show 0% on the Home screen.
Note:
Depending on local water quality conditions and usage, the filter may
require changing anywhere from 1,000 Ltrs to 10,000 Ltrs. You may also
need to replace the filter if you notice unpleasant odours or tastes.
To change the Filter:
• Open the door of the under sink unit.
• Relieve system pressure via the filter flush stop cock, a quick open and
close will do. Use the bucket to catch the discharge.
• Grasp filter cartridge, depress the red lever at the top right of the filter and
rotate the cartridge a quarter turn to the left, then gently pull down.
Page 24 of 28
The ability to change the maximum
dispensing time for both the hot and
cold water has been introduced. The
default settings for the maximum
dispensing times is 15 seconds. Here,
the operator may change both the hot
and cold dispensing times to between
5 and 15 seconds, in increments of 1
second. To edit the dispensing times:
1.
Press the [MENU] button for main
menu.
2.
Press the [Setting] button.
3.
Press the [Dispense Time] button.
4.
Select the option to change and
scroll using the up and down arrow
Keys

Filter Maintenance

Some water may drip from the filter
head (socket) during replacement.
Keep a towel handy to dry up any
drips.
(See also Section C)
802266NZ - HT-BCS; BCSH A-AV Compact User Guide - Feb 2016 - v2.01