Step 1.3 Drilling A Hole Through The Wall - Samsung AC777MNADCH User Manual

AC MNTDCH
Installation plate (1)
030/036
Remote control battery (2)
Installation Manual (1)
M4 x 16
Tapped Screws (2)
Tools
General tools
Vacuum pump
(Backward flowing
prevention)
Manifold gauge
Stud finder
Torque wrench
Pipe cutter
Reamer
Tools for test operation
Thermometer
Resistance meter
Electroscope
Remote control (1)
User Manual (1)
Remote Control Holder (1)
Pipe bender
Spirit level
Screwdriver
Spanner
Drill
L-wrench
Measuring tape
Step 1.3 Drilling a hole through the
wall
Before fixing the installation plate to a wall and then
fixing the indoor unit to the installation plate, a window
frame, or a gypsum board, you must determine the
position of a hole [with 2.56 inch (65 mm) inner diameter]
through which the pipe bundle (consisting of power and
communication cables, refrigerant pipes, and drain hose)
will pass and then drill that hole.
1 Determine the position of a 2.56 inch (65 mm) hole
in consideration of the possible directions of the pipe
bundle and the minimum distances between the hole
and the installation plate.
Left
Bottom right
<Possible directions of the pipe bundle>
CAUTION
If changing the pipe direction from left to right, do not
drastically bent it but slowly turn it in the opposite
direction as shown. Otherwise, the pipe may be
damaged in the process.
B
<Minimum distances between the hole and the
installation plate>
Model A
AC012MNADCH 1.42 (36) 2.36 (60) 2.56 (65) 1.42 (36)
AC018MNADCH 1.42 (36) 7.48 (190) 3.19 (81) 1.42 (36)
AC024MNADCH 1.30 (33) 4.33 (110) 4.33 (110) 1.30 (33)
Pipe bundle hole: Ø 2.56 inch (65 mm)
Right
Rear right or left
Pipe bundle hole
C
Unit : inch (mm)
B C D
English 39