Adjusting The Camera Angle - Samsung SMARTCAM SNH-V6431BN User Manual

when installing on a concrete wall
Fix the bracket on the wall using screws and
3.
anchors. First, mark the wall on which the
camera is to be installed as shown in the
figure.
On the mark, drill a hole to a depth of about
4.
3cm in the wall using a drill bit and drill with a
5mm diameter for concrete. Remove any
debris remaining in the hole after drilling.
Use caution when drilling to avoid injury.
`
J
Insert an anchor in each of the 2 holes for the
5.
screws, then hit the back of the anchor with a
hammer or a rubber mallet until it is
completely inserted.
10 · English
Insert a screw in each of the 2 holes in the
6.
wall, and tighten the screws using a Phillips
screwdriver.
Connect the adapter plug to the power
7.
terminal of the camera.
If the bracket hinge becomes loose, remove the
8.
rubber cover and tighten the screw using a
screwdriver.

adjusting the camera angle

Place the camera stand on a flat
1.
surface.
Adjust the camera's shooting angle as
2.
appropriate.
` If the bracket hinge becomes loose,
n
remove the rubber cover and tighten the
screw using a screwdriver, then adjust the
direction of the camera.