Insignia NS-AC10PWH8 User Manual page 19

Button Description
COOL and DRY modes–press to adjust the temperature setting up to 86°F (30°C) or down to 62°F (17°C), in one
degree increments. The temperature can be switched between Fahrenheit and Celsius by pressing
at the same time, or by pressing the °F/°C switching button on the remote control.
TIMER mode–press
 
and hold
NOTE: The temperature displayed is the room temperature, not the set temperature. In COOL, DRY, or AUTO
mode, the thermostat in the air conditioner runs the compressor until the set temperature is reached, then the
compressor cycles on and off to maintain the set temperature.
Press to set your air conditioner to turn off or turn on after a delay of up to 24 hours. The default is 0.
Automatic off–press
TIMER
one hour increments. The air conditioner automatically turns off when the set delay time is reached.
Automatic on–press
hour increments. The air conditioner automatically turns on when the set delay time is reached.
Press the TIMER button to see the delay time you have set on the LED display.
To change the set delay time (on or off), press the TIMER button, then adjust the time with the
buttons when the number begins to blink.
To cancel the Timer function, press the TIMER button, then press the
begins to blink to adjust the time to 0. You can also press the TIMER button, then press it again when the
number begins to blink.
NOTE: Do not unplug the air conditioner while using the Timer function. After setting the Timer function, if
you use the remote control to change to another mode without resetting the Timer function, the timer is reset.
Press to turn on the automatic oscillation, which varies the direction of the air flow to cool the room more
SWING
efficiently.
Running your air conditioner in DRY mode
If you run your air conditioner continually in DRY mode because of high
humidity or other reasons, the water collection tank should drain
continuously. To accomplish this:
1 Unplug your air conditioner and move it to a location where you can
work on it.
2 Remove the rubber plug from the unit.
3 Remove the filter case.
4 Install a 1/2 in. inside diameter drain hose on the back of the unit
where you removed the rubber plug. Use a hose clamp to make sure
that there are no leaks.
5 Replace the filter case.
6 Place the open end of the hose in a suitable location to drain
continuously.
7 Plug in your air conditioner and restart it.
10,000 or 12,000 BTU Portable Air Conditioner
 
to adjust the delay time from one to 24 hours, in one hour increments. If you press
, the set temperature or time changes automatically.
 
while the air conditioner is running to set the delay time from one to 24 hours, in
 
while the air conditioner is off to set the delay time from one to 24 hours, in one
www.insigniaproducts.com
 
 
buttons when the number
 
and
19