Feedrolls; Install Wire Into The Feedhead - Firepower FP 95 Operating Manual

FIREPOWER FP 95 FC
D-Ring
Wire Spool
Spool Locking
Knob
Figure 3-1: 4" Spool Installation

3.07 Feedrolls

A feedroll consists of two different sized grooves. As delivered
from the factory, the drive roll is installed for .030" (0.8mm)
Firepower FP 95 FC.
The branding inside at the end of the feedroll refers to the size
nearest to the mark
This also applies to optional feedrolls which are available for this
machine.
Figure 3-2 : Feedroll Example
Manual 0-5122
Hub
Spring
Art # A-09088
.030
0.8
Art # A-07963

3.08 Install Wire into the Feedhead

WARNING
ELECTRIC SHOCK CAN KILL! Make certain
the machine is unplugged from the power
receptacle. Do not plug machine in until told
to do so in these instructions.
If Not Installed Load the Wire Spool per directions in section 3.06
onto the hub so that the wire will feed off the spool as the spool
rotates counter- clockwise.
CAUTION
!
Use care in handling the spooled wire as it
will tend to "unravel" when loosened from
the spool. Grasp the end of the wire firmly
and do not let go of it. Make sure that the
end of the wire is free of any burrs and is
straight.
Pressure Adjust Device
Wire Spool
Figure 3-3: Wire Feeder Components
Route the Wire Through the Feedhead
1. Loosen Pressure Adjust Device (Fig. 3-3).
2. Open Pressure Adjust Device (Fig. 3-3).
3. Open Pressure Arm (Fig. 3-4).
4. Place the end of the wire into the Inlet Wire Guide, feed-
ing it over the Feedroll. Make certain that the proper
groove is being used (Fig. 3-5).
5. Pass the wire into the Gun Liner of the Gun Cable End
(Fig. 3-5).
6. Close the Pressure Arm (Fig. 3-5).
7. Close the Pressure Adjust Device. Tighten it to a "snug"
condition (Fig. 3-6).
8. Figure 3-6 shows the result with the wire installed.
3-2
INSTALLATION
Pressure Arm
Gun Cable
Inlet Wire Guide Feed Roll
Installation