Toro Groundsmaster 345 Operator's Manual page 12

REMOVE BATTERY FROM CHASSIS
1. Release the two latches holding instrument cover in
place. Carefully remove instrument cover to expose the
battery.
2. Remove two wing nuts and hold down strap that
secures battery (Fig. 2). Lift battery out of chassis. Keep
wing nuts and hold down strap in safe place for later use.
3. Activate and charge battery, refer to Activate and
Charge Battery.
4
Figure 2
1. Wing nuts
2. Hold down strap
INSTALLING SEAT
The Groundsmaster 345 is shipped without the seat
assembly. Either optional Seat Kit, Model No. 30623 or
30625 must be installed.
Seat Kit, Model No. 30623, Standard Seat
1. Loosely secure (2) R–clamps to right side of seat
bottom with (2) capscrews and flatwashers supplied in
kit (Fig. 3). Install manual tube into R–clamps and
tighten capscrews (Fig. 3).
Figure 3
1. R–clamps
2 Seat support
3. Manual tube
SET–UP INSTRUCTIONS
3
2
1
3. Positive terminal
4. Negative terminal
2
3
1
4
2. Mount seat pivot bracket to frame with (2) flange
screws supplied in kit (Fig. 4).
1
Figure 4
1. Seat Pivot Bracket
3. Mount seat and seat support to seat pivot bracket
with pivot shaft and roll pin (Fig. 5).
2
Figure 5
1. Pivot shaft
4. Hold seat up with seat support rod (Fig. 6).
1
Figure 6
1. Seat Support Rod
5. Connect seat switch connector to traction unit wire
harness connector.
Seat Kit, Model No. 30625, Deluxe Seat with Model
30628 Seat Adapter Kit:
1. Mount seat suspension assembly to (4) capscrews
on seat bottom and secure with (4) lockwashers,
flatwashers and nuts (Fig. 7).
2. Loosely secure (2) R–clamps to right side of seat
bottom with (2) capscrews and flatwashers supplied in
kit (Fig. 7). Install manual tube into R–clamps and
tighten capscrews (Fig. 7).
1
2. Roll pin
11