Output Mode; How To Change The Direction Of The Motor Rotation - ABB ACSM1 Control Panel User Manual

Output mode

In the Output mode, you can:
• monitor actual values of up to three signals
• change the direction of the motor rotation
• set the speed, frequency, torque or position reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
The top right corner of the display shows the reference
value. The center can be configured to show up to three
signal values or bar graphs.

How to change the direction of the motor rotation

Step Action
1. If you are not in the Output mode, press
2. If the drive is in remote control (REM shown on the status line), switch to local
control by pressing
the mode and then returns to the Output mode.
3. To change the direction from forward ( shown on the status line) to reverse (
shown on the status line), or vice versa, press
EXIT
. The display briefly shows a message about changing
LOC
REM
EXIT repeatedly.
repeatedly until you get there.
DIR
.
30.00rpm
LOC
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
Display
30.00rpm
REM
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
30.00rpm
LOC
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
Operation
21