Toro 74216 Operator's Manual page 40

3. Remove hydraulic reservoir cap and temporarily cover
opening with a plastic bag and rubber band to prevent
all hydro fluid from draining out.
4. Place drain pan under filter, remove the old filter and
wipe the filter adapter gasket surface clean (Fig. 54).
Figure 54
1. Hydraulic filter
5. Apply a thin coat hydro fluid to the rubber gasket on
the replacement filter (Fig. 55).
6. Install replacement hydraulic filter onto the filter
adapter. Do not tighten.
7. Remove plastic bag from tank opening and allow filter
to fill with hydro fluid.
8. When fluid overflows filter turn the oil filter clockwise
until the rubber gasket contacts the filter adapter, then
tighten the filter an additional 1/2 turn (Fig. 55).
9. Clean up any spilled fluid.
10. If there is no fluid, add fluid to reservoir
approximately a 1/4 (6mm) below the top of baffle.
11. Start engine and let run for about two minutes to purge
air from the system. Stop the engine and check for
leaks. If one or both wheels will not drive, refer
Bleeding Hydraulic System, page 40.
12. Recheck level while fluid is warm. Add fluid to raise
level to top of the baffle, if required. Do not over fill.
1. Hydraulic filter
2. Gasket
1
Bleeding Hydraulic System
The traction system is self bleeding, however, it may be
necessary to bleed the system if fluid is changed or after
work is performed on the system.
1. Raise rear of the machine so wheels are off the ground
and support with jack stands.
2. Start the engine and run at idle speed. Engage traction
on one side and spin the wheel by hand.
3. When the wheel begins to spin on its own, keep it
engaged until wheel drives smoothly (minimum
2 minutes).
4. Check hydraulic fluid level as it drops and add as
required to maintain proper level.
5. Repeat procedure on opposite wheel.
Check Hydraulic Lines
After every 100 operating hours, check hydraulic lines and
hoses for leaks, loose fittings, kinked lines, loose
mounting supports, wear, weather and chemical
deterioration. Make necessary repairs before operating.
Note: Keep areas around hydraulic system clean from
grass and debris build up.
40
1
3
2
Figure 55
3. Adapter
m–1256