Assembly; Loose Parts; Install Drive Wheels; Tire Pressure - Toro 74216 Operator's Manual

Assembly

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
Description
Rear Wheels
Retaining rod
Bolt 5/16-18 x 1 (26 mm)
Locknut 5/16
Control lever–right
Control lever–left
Bolt 3/8-1 x 1 (26 mm)
Spring washer 3/8
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card

Install Drive Wheels

1. Uncrate mower.
2. Remove wheel nuts from rear wheel hubs.
3. Align holes. Mount drive wheels with the valve stem
to the outside of the traction unit.
4. Secure using wheel nuts provided. Torque to 95 ft-lbs
(128 N M).

Tire Pressure

Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
Qty. Use
2 Install wheels to traction unit
1
1 Install seat rod
1
1
1
Install motion control levers
4
4
2
1
Read before operating machine
1
1
1 Fill out and return to Toro
1. Valve stem

Install Seat Retaining Rod

1. Tilt seat up. Remove 5/16 (8mm) locknut from bolt
attaching seat retaining rod to seat frame (Fig. 3).
14
1
m–1872
Figure 2