Removing The Mower From Storage - Toro Recycler 20656 Operator's Manual

Fully Folded Position
The blade is sharp; contacting the blade can
result in serious personal injury.
Stop the engine and wait for all moving parts to
stop before leaving the operating position.
1. Go to the left side of the lawn mower.
2. Step on the
handle release
lever.
m-7312
3. Raise the
handle to the
vertical position.
4. Push in on the lower left handle leg until the the
handle moves freely forward.
5. Rotate the
handle forward.
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
S
Do not damage the cables when folding or
unfolding the handle.
S
If a cable is damaged, contact an Authorized
Service Dealer.
15
6. Loosen the
handle knobs until
you can move the
upper handle
freely.
7. Fold the upper
handle rearward as
shown.
Important: Route the cables to the outside of the
handle knobs as you unfold the upper handle.
8. To unfold the handle, refer to Unfolding the
Handle on page 4.
Removing the Mower from
Storage
1. Remove the spark plug and spin the engine
rapidly using the starter to blow the excess oil from
m-7309
the cylinder.
2. Install the spark plug and tighten it with a torque
wrench to 15 ft-lb (20 N
m).
3. Charge the battery.
4. Connect the wire to the spark plug.
m-7309
3352-591
m-6289
m-7309