Adjusting The Cutting Height; Adjusting The Handle Height - Toro Recycler 20656 Operator's Manual

Filling the Fuel Tank
Fill the fuel tank with fresh unleaded regular gasoline
from a major name-brand service station.
Important: To reduce starting problems, add fuel
stabilizer to the fuel all season, mixing it with gasoline
less than 30 days old.
1/2 in. (1 cm)
m-7318

Adjusting the Cutting Height

Adjust the cutting height
as desired. Set all four
wheels to the same
height.

Adjusting the Handle Height

Squeeze the bottom of
the handle halves
together (as shown) and
change the handle holes
in which the pins (A) are
mounted, as follows:
Raise the handle
•
using hole (B).
Lower the handle
•
using hole (C).
6
Checking the Engine Oil
Level
1. Remove the dipstick, wipe it clean, and fully
install the dipstick.
2. Remove the dipstick and check the oil level. If the
oil level is below the Add mark on the dipstick,
slowly pour oil into the oil fill tube to raise the oil level
m-7317
to the Full mark on the dipstick. Do not overfill.
(Max. fill: 20 oz., type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or
higher.)
3. Install the dipstick.
m-7317
C
B
A
3352-591
m-7317
2,
1-1/4,
2-3/8,
1-5/8,
FRONT
m-5629
m-5614
m-7310
2-3/4,
3-1/2,
4-1/4,
3-1/8,
3-7/8,
m-5605a
m-5612a