Fuse; Washing The Underside Of The Mower - Toro 74502 Operator's Manual

Fuse

The electrical system is protected by fuses. It requires no
maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse: Main F1—30 amp, blade-type
Charge Circuit F2—25 amp, blade-type
Optional Headlight Kit—10 amp, blade type
1. Raise the seat to gain access to the fuse holder (Fig. 46).
2. To replace a fuse, pull out on the fuse to remove it
(Fig. 46).
Figure 46
1. Main—30 amp
2. Charge circuit—25 amp
Washing the Underside of the
Mower
After each use, wash the underside of the mower to prevent
grass buildup for improved mulch action and clipping
dispersal.
1. Park the machine on a hard level surface, disengage the
PTO, stop the engine, and remove the ignition key.
2. Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high (Fig. 47).
Note: Spread petroleum jelly on the washout fitting o-ring
to make the coupling slide on easier and protect the o-ring.
1
2
3
m–5144
3. For optional Headlight
Kit—10 amp
34
Figure 47
1. Washout fitting
2. Coupling
3. Lower the mower to the lowest height-of-cut.
4. Sit on the seat and start the engine. Engage the PTO and
let the mower run for one to three minutes.
5. Disengage the PTO, stop the engine, and remove the
ignition key. Wait for all moving parts to stop.
6. Turn the water off and remove the coupling from the
washout fitting.
Note: If the mower is not clean after one washing, soak it
and let it stand for 30 minutes. Then repeat the process.
7. Run the mower again for one to three minutes to
remove excess water.
Warning
A broken or missing washout fitting could expose
you and others to thrown objects or blade contact.
Contact with blade or thrown debris contact will
cause injury or death.
Replace broken or missing washout fitting
immediately, before using mower again.
Plug any hole(s) in mower with bolts and
locknuts.
Never put your hands or feet under the mower
or through openings in the mower.
1
3
2
m–5173
3. Hose