Servicing The Cooling System - Toro 74251 Operator's Manual

With 60in turbo force side discharge mower

Hide thumbs Also See for 74251:

Operator's manual (64 pages)

Operator's manual (60 pages)

Table Of Contents

Table of Contents

Note: Dispose of the used oil at a certified recycling

center.

Figure 42

1. Oil drain

5. Slowly pour approximately 80% of the specified oil

into the filler cap (Fig. 41). Refer to Servicing the

Engine Oil, page 35.

6. Check the oil level; refer to Checking the Oil Level,

page 35.

7. Slowly add additional oil to bring it to the full mark.

Changing the Oil Filter

Replace the oil filter every 200 hours or every other oil

change.

Note: Change the oil filter more frequently when

operating conditions are extremely dusty or sandy.

1. Drain the oil from the engine; refer to Changing the

Oil, page 35.

2. Remove the old filter and wipe the filter adapter

(Fig. 43) gasket surface.

3. Pour new oil of the proper type in through the center

hole. Stop pouring when the oil reaches the bottom of

the threads. Allow a minute or two for the oil to be

absorbed by the filter material.

4. Apply a thin coat of new oil to the rubber gasket on

the replacement filter (Fig. 43).

1. Oil filter

2. Gasket

m–5030

5. Install the replacement oil filter to the filter adapter.

Turn the oil filter clockwise until the rubber gasket

contacts the filter adapter; then tighten the filter an

additional 1/2 turn (Fig. 43).

6. Fill the crankcase with the proper type of new oil;

refer to Servicing the Engine Oil, page 35.