Engine Oil - Toro 74701 Operator's Manual

Engine Oil

Change the oil after every 100 operating hours.
Oil Type: Detergent oil (API service SG, SH, SJ, or higher)
Crankcase Capacity: w/filter, 2.1 qt. (2 l)
Viscosity: See the table below.
USE THESE SAE VISCOSITY OILS
5W–20, 5W–30
–20 0 20
32 40
F
–30 –20 –10 0
C
Checking the Oil Level
1. Park the machine on a level surface, disengage the PTO,
stop the engine, and remove the key.
2. Clean around the oil dipstick (Fig. 15) so that dirt
cannot fall into the filler hole and damage the engine.
3. Unscrew the oil dipstick and wipe the metal end clean
(Fig. 15).
4. Slide the oil dipstick fully into the filler tube, but do not
thread it onto the tube (Fig. 15). Pull the dipstick out
and look at the metal end. If the oil level is low, slowly
pour only enough oil into the filler tube to raise the
level to, but not over, the "F" mark on the dipstick.
Important
Do not overfill the crankcase with oil
because the engine may be damaged.
10W–30
80 100
60
10 20 30 40
2
1. Oil dipstick
2. Filler tube
Changing and Draining the Oil
1. Start the engine and let it run for five minutes. This
warms the oil so that it drains better.
2. Park the machine so that the drain side is slightly lower
than the opposite side to ensure that the oil drains
completely. Then disengage the PTO, set the parking
brake, stop the engine, and remove the key.
3. Place a pan below the oil drain. Remove the oil drain
cap (Fig. 16).
4. When the oil has drained completely, install the drain
cap.
Note: Dispose of the used oil at a certified recycling center.
1
1. Oil drain cap
21
3
1
Figure 15
3. Metal end
Figure 16
2. Oil dipstick
m–5142
2
m–5140