Toro 41106 Operator's Manual page 45

Problem
The Area is inaccurate.
The Distance is inaccurate.
The monitor does not display
Application Rate or Total Volume. A li ti R t T t l V l
The Total Volume is inaccurate.
The monitor displays 6553.5 when
in the Application Rate setting.
The monitor is erratic in operation.
The displayed measurements do
not make sense.
The monitor reads "OFL."
Possible Causes
1. The sprayer width is not
correctly entered.
2. The speed sensor is not
calibrated correctly.
3. The speed sensor is damaged.
1. The speed sensor is not
calibrated correctly.
2. The speed sensor is damaged.
y 1. The monitor cable is loose.
2. The flow meter is dirty or
clogged.
3. The flow meter is not calibrated
correctly.
4. The flow meter is damaged.
1. The flow meter is dirty or
clogged.
2. The flow meter is not calibrated
correctly.
3. The flow meter is damaged.
1. The monitor is not receiving
data from the speed sensor.
1. A two-way radio is too close to
the monitor or its cables.
1. The Units of Measurement is
set to a system other than what
you expect.
1. The data has exceeded the
maximum allowed.
1. Check and set the appropriate
Width in the calibration mode.
2. Calibrate the speed sensor.
3. Contact your Authorized
Service Dealer.
1. Calibrate the speed sensor.
2. Contact your Authorized
Service Dealer.
1. Connect the monitor cable.
2. Clean the flow meter.
3. Calibrate the flowmeter
4. Contact your Authorized
Service Dealer.
1. Clean the flow meter.
2. Calibrate the flowmeter
3. Contact your Authorized
Service Dealer.
1. Contact your Authorized
Service Dealer.
1. Keep two-way radios away
from the monitor and its cables.
1. Check the Units of
Measurement to ensure that it
is set correctly.
1. Press and hold the [Reset]
button to clear the monitor.
45
Corrective Action