Filling The Engine With Oil - Toro 38635 Operator's Manual

Figure 9
1. Short rod
4. Insert the front end of the rod into the opening in the
back of the chute gear cover until it slides into the chute
gear (Figure 10).
Figure 10
5. Align the holes in the nested ends of the rods and insert
2 carriage bolts (in the loose parts bag) through the
short rod from the left side of the snowthrower (from
the operating position).
6. Insert the cable clip that supports the deflector cable
onto the forward carriage bolt, and secure the carriage
bolts with locknuts from the loose parts bag (Figure 11).
Figure 11
1. Cable clip
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
2. Long chute control rod
2. Deector cable
4. Connecting the Wire to the
Headlight
1. Insert the wire connector on the loose end of the wire
straight into the back of the headlight until it is securely
in place (Figure 12).
Figure 12
1. Plastic clip on wire
connector
2. U-bolt
Note: Ensure that the plastic clip on the wire
connector is on the bottom (Figure 12).
2. Secure a cable tie (from the loose parts bag) around the
wire and the handle about an inch (2.5 cm) below the
U-bolt (Figure 12).

5. Filling the Engine with Oil

Your snowthrower comes with 26 oz. of oil in the engine.
Note: Before starting the engine, check the oil level and
add oil if necessary.
Max. fill: 26 oz. (0.77 l), type: automotive detergent oil with
an API service classification of SF, SG, SH, SJ, SL, or higher.
•
For temperatures above 32°F (0°C), use SAE 30W.
•
For temperatures between 0°F and 32°F (-18°C to 0°C),
use SAE 5W30 or SAE 10W.
•
For air temperatures below 0°F (-18°C), use SAE 0W30.
1. Remove the dipstick and slowly pour oil into the oil
fill tube to raise the oil level to the Full mark on the
dipstick. Do not overfill.(Figure 13).
8
3. Cable tie