Toro 38635 Operator's Manual page 20

Figure 51
3. Remove the bulb straight out from the back of the
headlight (Figure 52).
Figure 52
4. Insert a new bulb into the back of the headlight (Figure
53).
Figure 53
5. Turn the base of the bulb clockwise until it is snug
(Figure 54).
Figure 54
6. Insert the wire connector straight into the back of the
headlight until it is securely in place (Figure 55).
Figure 55
Storage
•
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the snowthrower in an enclosure
near an open flame.
•
Allow the engine to cool before storing it.
Preparing the Snowthrower
for Storage
1. On the last refueling of the year, add fuel stabilizer to
fresh fuel as directed by the engine manufacturer.
2. Run the engine for 10 minutes to distribute the
conditioned fuel through the fuel system.
3. Loosen the hose clamp that secures the fuel line to the
valve and slide the fuel line off the fuel shutoff valve.
4. Open the fuel shutoff valve and allow the fuel to drain
out of the fuel tank into an approved fuel container.
5. Install the fuel line onto the fuel shutoff valve and
secure it with a hose clamp.
6. Run the snowthrower until the engine stops from
running out of fuel.
7. Prime the engine and start it again.
8. Allow the engine to run until it stops. When you can no
longer start the engine, it is sufficiently dry.
9. Stop the engine and allow it to cool.
10. Remove the ignition key.
11. Disconnect the spark plug wire.
12. Remove the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole, and pull the starter rope slowly
20