Using The Z Stand - Toro 74232 Operator's Manual

Warning
Loading a unit onto a trailer or truck increases
the possibility of backward tip–over and could
cause serious injury or death.
Use extreme caution when operating a unit on a
ramp.
Use only a single, full width ramp; DO NOT use
individual ramps for each side of the unit.
If individual ramps must be used, use enough
ramps to create an unbroken ramp surface
wider than the unit.
Do not exceed a 15 degree angle between ramp
and ground or between ramp and trailer or
truck.
Avoid sudden acceleration while driving unit up
a ramp to avoid tipping backward.
Avoid sudden deceleration while backing unit
down a ramp to avoid tipping backward.
1
1
m–6841
Figure 26
1. Trailer
2. Full width ramp
3. Not greater than
15 degrees
4
2
3
4. Full width ramp—side
view
25

Using the Z Stand

The Z Stand is used for raising the front end of the
machine. This allows for cleaning of the deck and
removal of the blades.
Warning
Unit could fall onto someone and cause serious
injury or death.
Use extreme caution when operating unit on
Z Stand.
Use only for cleaning deck and removing
blades.
Do not keep unit on Z Stand for extended
periods of time.
Always shut engine off and set parking brake
before performing any maintenance to deck.
Driving up onto the Z Stand
Important
Use the Z Stand on a level surface.
1. Raise deck to transport position.
2. Remove bracket pin (Fig. 27).
2
5
1
3
Figure 27
1. Z Stand
2. Latch
3. Bracket
4
m–5599
4. Bracket Pin
5. Bottom of slot