Cab Controls - Toro 31598 Operator's Manual

Note: The decks will not lower while in the High speed
range. and the decks will not raise or lower if the operator is
out of the seat when the engine is running.
Key Switch
The key switch (Figure 11) has three positions: Stop,
Run/Preheat, and Start.
1. PTO switch
2. Key switch
3. Traction assist switch
4. Lift switches
PTO Switch
The PTO switch (Figure 11) has two positions: Out (start)
and In (stop). Pull the PTO button out to engage the
implement or cutting unit blades. Push in the button to
disengage the implement operation.
Traction Assist Switch
When mowing (low speed range), press and hold the
traction assist switch (Figure
performance in compromised operating conditions.
Note: The traction assist only engages in Mow- Forward.
The traction assist will not engage in Mow-Reverse or High
speed range.
Cruise Control Switch
The cruise control switch
machine. Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the cruise
control function and the front of the switch sets the desired
ground speed.
Note: Pressing either brake pedal or moving the traction
pedal into the reverse position, for one second, will also
disengage the cruise control.
Figure 11
5. Cruise control
6. Light switch
7. Power point (on the right
side of console)
11) to enhance traction drive
(Figure 11) sets the speed of the
Light Switch
Press the lower edge of the switch
lights. Press the upper edge of the switch to turn off the lights.
Audible Alarm (Console)
The alarm is activated when a fault is detected.
The buzzer sounds:
•
continuous when the engine sends a stop fault.
•
with a short pulse when the engine sends a check engine
fault.
•
when there is low fuel.
Power Point
The power point, located next to the console on the side
of the power center, is used to power optional electrical
accessories (Figure 11).

Cab Controls

3
2
1
9
1. Air recirculation control
2. Fan control
3. Temperature control
4. Wind shield wiper switch
5. Power outlet
Air Recirculation Control
Sets the cab to either recirculate the air in the cabin or to draw
air into the cabin from outside
•
Set it to recirculate the air when using the air-conditioning.
•
Set it to draw air in when using the heater or fan.
Fan Control
Rotate the fan control knob to regulate the speed of the fan
(Figure 12).
20
(Figure 11) to turn on the
4
8
g028431
7
Figure 12
6. Lights switch
7. Turn signal
8. Flashers switch
9. Air conditioning switch
(Figure 12).
5
6