Servicing The Spark Plug - Toro 74272CP Operator's Manual

With 60in or 72in turbo force side discharge mower

Hide thumbs Also See for 74272CP:

Operator's manual (60 pages)

Table Of Contents

Table of Contents

Note: Dispose of the used oil at a recycling

center.

Figure 38

1. Oil drain valve

9. Slowly pour approximately 80% of the

speciﬁed oil into the ﬁller tube (Figure 37).

10. Check the oil level; refer to Checking the

Engine Oil Level.

11. Slowly add the additional oil to bring it to the

Full mark.

Changing the Engine Oil Filter

Replace the oil ﬁlter every 200 operating hours

thereafter.

Note: Change the oil ﬁlter more frequently when

operating conditions are extremely dusty or sandy.

1. Drain the oil from the engine; refer to

Changing the Engine Oil.

2. Remove the old ﬁlter and wipe the ﬁlter

adapter gasket surface (Figure 39).

2. Oil drain hose

Figure 39

1. Engine oil lter

3. Pour new oil of the proper type into the center

hole in the new oil ﬁlter. Stop pouring when

the oil reaches the bottom of the threads.

Allow a minute or two for the oil to be

absorbed by ﬁlter material.

4. Apply a thin coat of new oil to the rubber

gasket on the replacement ﬁlter (Figure 40).

5. Install the replacement oil ﬁlter to the ﬁlter

adapter. Turn the oil ﬁlter clockwise until

the rubber gasket contacts the ﬁlter adapter,

then tighten the ﬁlter an additional 1/2 turn

(Figure 40).

Figure 40

1. Oil lter

2. Gasket

6. Fill the crankcase with the proper type of new

oil; refer to Changing the Oil.