Positioning The Flow Baffle - Toro 74272CP Operator's Manual

the cam lock. Adjust the cam lock until the
desired locking pressure is achieved.
Figure 20
1. Cam lock
2. Lever
Positioning the Flow Bafe
The following figures are only recommendations
for use. Adjustments will vary by grass type,
moisture content, and height of grass.
Note: If the engine power draws down and the
mower ground speed is the same, open up the
baffle.
Position A
This is the full rear position. The suggested use
for this position is a follows (Figure 21).
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
Figure 21
Position B
Use this position when bagging.
3. Rotate cam to increase or
decrease locking pressure
4. Slot
Figure 22
Position C
This is the full open position. The suggested use
for this position is as follows.
• Use in tall, dense grass mowing conditions.
• Use in wet conditions.
• Lowers the engine power consumption.
• Allows increased ground speed in heavy
conditions.
• This position is similar to the benefits of the
Toro SFS mower.
Figure 23
24