Shifting - Yamaha YFM700RSE Owner's Manual

4. Completely close the throttle lever and start
the engine by pushing the start switch.
TIP
If the engine fails to start, release the start switch,
then push it again. Pause a few seconds before
the next attempt. Each cranking should be as
short as possible to preserve battery energy. Do
not crank the engine more than 10 seconds on
each attempt.
ECB00164
NOTICE
6
For maximum engine life, never accelerate
hard when the engine is cold!
EBU20534

Shifting

This ATV has a 5-speed forward and 1-speed re-
verse transmission. The transmission allows you
to control the amount of power you have available
at a given speed or for starting, accelerating,
climbing hills, etc.
To shift into neutral, release the throttle lever, ap-
ply the clutch, and then repeatedly depress the
shift pedal until it stops.
When it stops, it will be in first gear. Raise the ped-
al slightly to reach the neutral position, and then
release the clutch.
5
4
3
2
N
1
2
R
3
1. Shift pedal
2. Neutral position
3. Reverse position
EBU20594
To start out and accelerate
1. Release the throttle lever, apply the front or
rear brake, and then release the parking
brake.
2. Pull the clutch lever to disengage the clutch.
6-2
1